RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
Fig.32 Vacuum Reservoir Remove/Install
6. Disconnect the vacuum supply hose from the vacuum reservoir, which is secured to the dash panel near the right end of the cowl plenum.
7. Remove the two nuts that secure the reservoir to the studs on the dash panel near the right end of the cowl plenum.
8. Remove the vacuum reservoir from the dash panel studs.
INSTALLATION
1. Install the vacuum reservoir on the dash panel studs. Tighten the mounting nuts to 2.8 Nm (25 in. lbs.).
2. Connect the vacuum supply hose to the vacuum reservoir.
3. Install the plastic screws that secure the cowl plenum cover/grille panel to the studs on the cowl top panel.
4. Install the weatherstrip along the front edge of the cowl plenum cover/grille panel and the cowl plenum panel.
5. Install the wiper arms on the wiper pivots. Refer to Wipers/Washers for the procedures.
6. Connect the battery negative cable.
