RAM 2500 Van V8-5.2L Prop VIN 2 (2000)
8. Pull up on the CAB harness connector lock release and remove the connector from the controller.
9. Remove controller mounting screws and
INSTALLATION
1. Position the controller on the mounting bracket and install the mounting screws.
2. Install the CAB harness connector into the controller and push down on the connector lock.
3. Install the RWAL valve harness connector into controller.
4. Install the battery and power distribution center mount.
5. Install the power distribution center.
6. Install the battery and battery cables.
7. Install the reservoir in the engine compartment. Connect the pump motor connector and pump hose.
8. Install the washer reservoir mounting screws.
