RAM 3500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1998)
Forward Battery Tray Nuts
5. From under left front wheel opening, remove 2 forward battery tray nuts.
Battery Tray Mounting
6. Remove 2 nuts and 2 bolts holding battery tray to vehicle.
7. Disconnect servo cable at throttle body. Refer to Servo Cable Replacement.
8. Position battery tray up far enough for access to speed control servo electrical connector and vacuum line.
9. Disconnect electrical connector and vacuum line at servo.
10. Position battery tray with attached servo assembly to gain access to 2 servo mounting nuts.
11. Remove 2 mounting nuts holding servo cable sleeve to bracket.
12. Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip and remove clip. Note: The servo
mounting bracket displayed in is a typical bracket and may/may not be applicable to this model vehicle.
13. Remove servo from mounting bracket.
INSTALLATION
1. Position servo to mounting bracket.
