RAM 3500 Truck 2WD L6-359 5.9L DSL Turbo VIN D FI (1998)
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
3. Insert servo studs through holes in servo mounting bracket.
4. Insert servo studs through holes in servo cable sleeve.
5. Install servo mounting nuts and tighten to 8.5 N.m (75 in. lbs.) torque.
6. Connect vacuum line to servo.
7. Connect electrical connector to servo terminals.
8. Connect servo cable to throttle body Refer to Servo Cable Replacement.
9. Install battery tray Tighten all battery tray mounting hardware to 16 N.m (140 in. lbs.) torque.
10. Position battery into battery tray
11. If equipped, install battery heat shield.
12. Install battery holddown clamp. Tighten bolt to 4 N.m (35 in. lbs.) torque.
13. Connect negative battery cable(s) to battery(s).
14. Before starting engine, operate accelerator pedal to check for any binding.
