RAM 3500 Truck 2WD L6-5.9L DSL Turbo VIN 7 (2002)
Starter Relay: Service and Repair
REMOVAL
1. Disconnect and isolate negative battery cable (both negative cables if diesel).
Fig. 14 Power Distribution Center
2. Remove cover from Power Distribution Center (PDC) (Fig. 14).
3. Refer to PDC cover for relay identification and location.
4. Remove starter relay from PDC.
INSTALLATION
1. Position starter relay in proper receptacle in PDC.
2. Align starter relay terminals with terminal cavities in PDC receptacle.
3. Push down firmly on starter relay until terminals are fully seated in terminal cavities in PDC receptacle.
4. Install PDC cover.
5. Reconnect negative battery cable(s).
