RAM 3500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
2. Install the lower part of the shock (5) into the lower control arm shock bushing (7).
3. Install and position bolt (6) so head of bolt is facing rearward of vehicle and hand start nut. Tighten the bolt (6) & nut to 81 Nm (60 ft. lbs.).
4. Install the upper ball joint to the knuckle and install the retaining nut.
5. Install and tighten the axle hub nut.
6. Install the stabilizer link lower nut.
7. Reconnect the wheel speed sensor wiring to the knuckle and upper control arm.
8. Install the rotor.
9. Install the caliper adapter with the caliper.
10. Remove the support from the lower control arm outboard end.
11. Install the tire and wheel assembly.
12. Remove the support and lower the vehicle.
