RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Rear Door Panel: Service and Repair
Rear Door Trim Panel - Installation
INSTALLATION
Except Mega Cab Models
1. If equipped, connect the door wire harness (2) to the power door switch assembly.
CAUTION: The door trim panel is attached to the door by molded plastic retaining clips that are integral to the door trim panel. Do not force
the door trim panel onto the door or damage to the trim panel and/or the power switch assembly will occur.
2. Position the door trim panel (5) and align the molded plastic retaining clips (3) to the door (1).
3. Push the door trim panel straight downward until all of the retaining clips are fully engaged to the door.
4. Install the screw (4) that secures the door trim panel to the screw insert located in the center of the door.
5. if equipped, install the manual window crank.
Mega Cab Models
1. If equipped, connect the door wire harness (2) to the power door switch assembly.
CAUTION: The door trim panel is attached to the door by molded plastic retaining clips (4) that are integral to the door trim panel. Do not
force the door trim panel onto the door or damage to the trim panel and/or the power switch assembly will occur.
2. Position the trim panel to the door and insert the door lock (1) through the hole in the trim panel.
3. Position the door trim panel and align the molded plastic retaining clips (4) to the door slots (5).
4. Push the door trim panel straight downward until all of the retaining clips are fully engaged to the door.
5. Install the screws (3).
6. if equipped, install the manual window crank.
