RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Sunroof / Moonroof Motor: Service and Repair
Sunroof Motor - Installation
INSTALLATION
WARNING: Do not attempt to move or reposition the sunroof glass panel or drive cables with the motor/module removed. Vehicle/sunroof
damage or personal injury may result.
WARNING: The sunroof must first be calibrated and the Motor/Module Initialization Procedure must be completed any time a sunroof
motor/module is replaced with a new component. Failure to perform this procedure could result in vehicle damage and/or
personal injury. See: Testing and Inspection/Programming and Relearning/Sunroof Position Calibration for the appropriate
procedure.
1. Position the power sunroof motor/module (1) in the vehicle.
2. Install the motor/module retaining screws (3). Tighten the screws to 4 Nm (35 in. lbs.).
3. Connect the motor/module electrical connector (2).
4. Partially install the vehicle headliner and connect all remaining sunroof electrical connectors, See: Interior Moulding / Trim/Headliner/Service and
Repair/Headliner - Installation.
5. Connect the battery negative cable.
6. Perform the sunroof position calibration See: Testing and Inspection/Programming and Relearning/Sunroof Position Calibration.
7. Perform the Motor/Module Initialization Procedure See: Testing and Inspection/Programming and Relearning/Motor/Module Initialization.
8. Complete the vehicle headliner installation, See: Interior Moulding / Trim/Headliner/Service and Repair/Headliner - Installation.
9. Verify proper operation of the power sunroof system.