RAM 3500 Chassis Cab Truck 2WD L6-6.7L DSL Turbo (2010)
Seat Heater: Service and Repair
Heater Pad - Removal
REMOVAL
NOTE: The factory installed heating elements (3) can be removed from the seat or seat back cushions by carefully peeling the element off
along the adhesive lines.
1. Disconnect and isolate the negative battery cable.
2. Remove the appropriate seat cushion, See: Seat Cover/Service and Repair/Seat Cushion Cover - Removal or seat back trim cover, See: Seat
Cover/Service and Repair/Seat Back Cover - Removal.
3. Disconnect the inoperative heated seat cushion or seat back element electrical connectors (2).
4. Remove the heater element from the foam pad by peeling the element away from the cushion, being careful not to remove excessive foam in the
process.