RAM 3500 HD Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Speed Sensor: Service and Repair
Sensor-Output Shaft Speed-Front
Removal
REMOVAL
1. Raise the vehicle on a suitable hoist.
2. Disengage the wiring connector from the front output shaft speed sensor (1).
3. Remove the front output shaft speed sensor from the transfer case.
Installation
INSTALLATION
1. Install the front output shaft speed sensor (1) into the transfer case. Tighten the speed sensor to 17 Nm (12.5 ft.lbs.).
2. Engage the wiring connector to the front output shaft speed sensor.
3. Lower the vehicle.
