Rampage L4-135 2.2L (1983)
Steering Gear: Adjustments
1. With rack placed in center position, attach rack support cover to gear housing, then tighten cover to specifications using torque wrench socket
MB990607-A or equivalent. Back off cover approximately 10°, then install and tighten locking nut to specifications.
2. Rotate pinion gear at a rate of one revolution every 4 to 6 seconds using preload socket CT-1108 and a suitable torque wrench. Total pinion
preload should be 5-11 lb-in.
NOTE: Measure starting torque through whole stroke of rack.
3. If measured values are not within specifications, readjust rack support cover, then recheck.
4. If still not within specifications, check rack support cover, rack support spring and rack support and replace parts as necessary.
