Rampage L4-135 2.2L (1983)
6. Tilt cage and inner race assembly and insert balls.
7. With shaft supported in a soft jawed vise, install boot.
8. Slide small end of boot over spacer ring and shaft, then position boot end in machined groove.
9. Install snap ring on shaft. When installing use care not to overexpand snap ring.
10. Position joint housing on shaft, then engage by tapping sharply with a soft-faced mallet.
11. Check to ensure that snap ring is properly seated, by attempting to pull joint from shaft.
12. Locate large end of boot over housing.
13. On G.K.N. units, secure boot clamps using tool No. C-4124.