Rampage L4-135 2.2L (1983)
Constant Velocity Joint Boot: Service and Repair
Inner CV Joint
Fig. 31 Driveshaft components. 1982 - 83 (Similar to 1984)
DISASSEMBLY
Driveshaft assembly should be identified before starting service procedure. Refer to "Driveshaft Identification."
1. Remove clamp and boot from joint and discard.
Fig. 32 Removing inner C/V joint tripod housing. A.C.I. units
2. On A.C.I. units, position tripod housing so all three rollers are flush with retaining tabs. Pull housing out by hand at a slight angle to pop one roller
at a time out of the retaining tabs. Do not hold joint at too severe an angle, as rollers may be damaged. The retaining tabs must not be bent during
removal or installation of tripod housing.
Fig. 33 Removing inner C/V joint tripod housing. Early model G.K.N. units