Sprinter 2500 V6-3.0L DSL Turbo (2008)
INSTALLATION
1. Position the door lock (5) into the door recess, connect electrical connectors (3) and (1).
CAUTION: Guide cables carefully when installing to prevent damage to the cables.
2. Connect cables (7), (6), (4) and (2).
3. Install the door lock bolts (1) and tighten to 10 Nm (89 in. lbs.).
4. Install the lower trim panel See: Sliding Door Interior Trim Panel/Service and Repair/Installation.
5. Connect the battery negative cable.
CAUTION: Guide cables carefully when installing to prevent damage to the cables.
6. If equipped, connect the cable (3) to the auxiliary lock (1).
7. Install bolts (2) to the auxiliary lock (1) and tighten to 10 Nm (89 in. lbs.).
Removal
REMOVAL