Sprinter 2500 V6-3.0L DSL Turbo (2008)
3. Raise and support the vehicle.
4. Remove the tire and wheel assembly.
5. Remove the rear half of the wheel well cover to allow the strut (2) to move.
6. Remove the lower stabilizer link at the spring plate.
7. Tip the strut and knuckle back to access the spring plate mounting bolts (2).
8. Remove the spring plate mounting bolts (2) to the lower control arm.
9. Remove the spring plate (1) and rubber block.
Installation
INSTALLATION
1. Install the spring stop plate (1) and rubber block to the lower control arm. Tighten the M10 bolts (2) to 58 Nm (43 ft. lbs.) or Tighten the M12
X1.5 bolts to 106 Nm (78 ft. lbs.) Plus an additional 90° turn.