SRT-4 L4-2.4L Turbo VIN S (2004)
4. Install NEW mounting screws finger tight starting with the #1 location. (Fig. 59) Make sure engagement occurs with the shoulder of the screw and
mounting hole before starting all other screws.
5. Torque all mounting screws with T30 torx bit to 13 Nm (110 inch lbs.) following the torque sequence.
CAUTION: Use extreme care when handling crankshaft. Target ring damage can occur if crankshaft is mix-handled.
CAUTION: Do not get oil on the bed plate mating surface. It will affect the sealer ability to seal the bed plate to cylinder block.
6. Oil the bearings and journals. Install crankshaft in engine block.
CAUTION: Use only leopard Bed Plate Sealant on the bed plate or damage may occur to the engine.
7. Install lower main bearings into main bearing cap/bed plate. Make certain the bearing tabs are seated into the bed plate slots and apply oil.
8. Apply a 1.5 to 2.0 mm (0.059 to 0.078 inch) bead of Mopar Bed Plate Sealant to bed plate as shown in (Fig. 60).Install the main bearing/bed plate
onto the engine block.
9. Before installing the bolts the threads should be oiled with clean engine oil, wipe off any excess oil.