SRT-4 L4-2.4L Turbo VIN S (2004)
18. Loosen and completely remove the two front bolts (one right and one left) attaching the front suspension crossmember to the frame rails of vehicle.
The right side bolt can be viewed in the mounting bolt figure (Fig. 9). The left side bolt is located in the same location on the other side of the
vehicle.
19. Loosen the two rear bolts (one right and one left) attaching the front suspension crossmember and lower control arms to the body of the vehicle
until they release from the threaded tapping plates in the body of the vehicle. Do not completely remove the rear bolts because they are designed to
disengage from the body threads yet stay within the lower control arm rear isolator bushing. This allows the lower control arm to stay in place on
the crossmember. The right side bolt can be viewed in the mounting bolt figure (Fig. 9). The left side bolt is located in the same location on the
other side of the vehicle.
20. Lower the front suspension crossmember using the transmission jack enough to allow the power steering gear to be removed from the rear of the
crossmember (Fig. 10). When lowering front suspension crossmember, do not let crossmember hang from lower control arms. The weight should
be supported by the transmission jack.
