SRT-4 L4-2.4L Turbo VIN S (2004)
Part 2 Of 2
2. Three wheel studs across from one another require removal from the hub flange. Rotate the hub to align each wheel mounting stud with the notch
in the bearing retainer plate before removal. Using Remover, Special Tool C-4150A (Fig. 24), press the three wheel mounting studs out of the hub
flange. Remove the wheel mounting studs from the hub through the open notch (Fig. 25).
3. Rotate the hub so the stud mounting holes in the hub are facing in the direction shown in the figure (Fig. 26).
4. Install the Bearing Splitter, Special Tool 1130, between the hub and the bearing retainer plate as shown (Fig. 26). Absence of the three wheel
mounting studs allows the bearing splitter to be installed behind the flange. Hand tighten the nuts to hold bearing splitter in place on steering
knuckle.