SRT-4 L4-2.4L Turbo VIN S (2004)
5. Place the steering knuckle face down in an arbor press supported by the bearing splitter as shown (Fig. 27).
6. Position Remover/Installer, Special Tool 6644-2, on the small end of the hub (Fig. 27). Using the arbor press, remove the hub from the wheel
bearing. The bearing race will normally come out of the wheel bearing with the hub as it is pressed out of the bearing.
7. Remove the bearing splitter from the steering knuckle.
8. Remove the three bolts mounting the bearing retainer plate to the steering knuckle (Fig. 28). Remove the bearing retainer plate from the steering
knuckle.