Stratus Coupe V6-3.0L VIN H (2001)
STEP 9. Check the harness wires between C-08 and ignition switch (ACC).
NOTE: After checking joint connector C-141 and junction block connector C-301 and C-308, check the wires. If joint connector C-141 and junction
block connector C-301 and C-308 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Is the harness wires between C-08 and ignition switch (ACC) in good condition?
YES: There is no action to be taken.
NO: Repair them. The multi-center display should work normally.
STEP 10. Check the multi-center display power supply circuit [ignition switch (IG1)] at the multi-center display connector C-08 by
backprobing.
1. Do not disconnect the multi-center display connector C-08 and measure at the harness side by backprobing.
2. Turn the ignition switch to "ON" position.
3. Measure the voltage between terminal 2 and ground by backprobing.
Q: Is the voltage approximately 12 volts (battery positive voltage).
YES: Replace the multi-center display. The multi-center display should work normally.
NO: Go to Step 11.
STEP 11. Check the multi-center display connector C-08 for damage.
Q: Is multi-center display connector C-08 in good condition?
YES: Go to Step 12.
NO: Repair or replace it. Refer to Harness Connector Inspection. The multi-center display should work normally.