Stratus Coupe V6-3.0L VIN H (2001)
1. Do not disconnect the multi-center display connector C-08 and measure at the harness side.
2. Turn the ignition switch to "ACC" position.
3. Measure the voltage between terminal 3 and ground by backprobing.
Q: Is the voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 10.
NO: Go to Step 8.
STEP 8. Check multi-center display connector C-08 for damage.
Q: Is multi-center display connector C-08 in good condition?
YES: Go to Step 9.
NO: Repair or replace it. Refer to Harness Connector Inspection. The multi-center display should work normally.