Stratus Coupe V6-3.0L VIN H (2001)
STEP 7. Check the harness wires between ETACS-ECU connector C-313 and ground.
NOTE: After checking junction block connector C-301, check the wires. If junction block connector C-301 is damaged, repair or replace it. Refer to
Harness Connector Inspection.
Q: Are the harness wires between ETACS-ECU connector C-301 and ground in good condition?
YES: There is no action to be taken.
NO: Repair them. Scan tool MB991502 should communicate with the SWS.
Inspection Procedure B-1
Tone alarm: Ignition key reminder tone alarm function does not work normally.
TECHNICAL DESCRIPTION (COMMENT)
The ETACS-ECU operates the ignition key reminder tone alarm function, based on input signals from the following switches:
-
Ignition switch (IG1)
-
Key reminder switch
-
Driver's door switch
If the function does not work normally, a defect on the relevant circuit or the ETACS-ECU may be suspected.
TROUBLESHOOTING HINTS
-
Malfunction of the key reminder switch
-
Malfunction of the driver's door switch
-
Malfunction of the ETACS-ECU
-
Damaged harness wires or connectors
DIAGNOSIS
Required Special Tools:
-
MB991223: Test Harness Set
-
MB991502: Scan Tool (MUT-II)
-
MB991529: Diagnostic Trouble Code Check Harness
STEP 1. Check the ETACS-ECU power supply circuit.
If the ignition switch is at "LOCK" (OFF) position, do all of the following functions operate?
-
Light reminder tone alarm function
-
Central door locking system
-
Hazard warning light
-
interior light dimming function
-
Theft-alarm system
Q: Does any function described above operate?
YES: Go to Step 2 <when using scan tool MB991502> or 3 <when using a voltmeter>.
NO: Check the ETACS-ECU battery circuit. Refer to Inspection Procedure P-1.
STEP 2. Check the input signal (by using scan tool MB991502).
Check the input signals from the following switches:
-
Ignition switch (IG1)