Stratus Coupe V6-3.0L VIN H (2001)
STEP 9. Check the harness wires between trunk lid actuator opener connector F-04 and ETACS-ECU connector C-312.
NOTE: After checking intermediate connector C-210, check the wires. If intermediated connector C-210 is damaged, repair or replace it. Refer to
Harness Connector Inspection.
Q: Are the harness wires between trunk lid opener actuator connector F-04 and ETACS-ECU connector C-312 in good condition?
YES: There is no action to be taken.
NO: Repair it. Refer to Harness Connector Inspection. The trunk lid opener function should work normally.
Inspection Procedure E-4
Keyless entry system: Encrypted code cannot be register
TECHNICAL DESCRIPTION (COMMENT)
The ETACS-ECU activates the encrypted code register mode according to the following switch signals:
-
Key reminder switch
-
Hazard warning light switch
If the encrypted code register mode is not set, the relevant input signal circuit or the ETACS-ECU may be detective.
If a transmitter can not be registered although the encrypted code register mode is set, the transmitter or the ETACS-ECU may be defective.
TROUBLESHOOTING HINTS
-
Malfunction of the key reminder switch
-
Malfunction of the hazard warning light switch
-
Malfunction of the transmitter
-
Malfunction of the ETACS-ECU
-
Damaged harness wires or connectors
DIAGNOSIS
Required Special Tools:
-
MB991223: Test Harness Set
-
MB991502: Scan Tool (MUT-II)
-
MB991529: Diagnostic Trouble Code Check Harness
STEP 1. Check the trouble symptom.
Q: Is the encrypted code register mode set?
YES: Go to Step 4.
NO: Go to Step 2 <when using scan tool MB991502> or 3 <when using a volt meter>.
STEP 2. Check the input signal (by using scan tool MB991502).
Check the input signals from the following switches:
-
Key reminder switch
-
Hazard warning light switch
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502.