Stratus Coupe V6-3.0L VIN H (2001)
1. Remove the combination meter.
2. Remove the door ajar warning light bulb. Then measure the resistance between the bulb terminals.
3. Install the bulb to the combination meter, and then measure the resistance between connector C-102 terminal 31 and connector C-103 terminal 15.
The resistance reading at this time should be much the same as the resistance measured at Step (2).
Q: Are the two resistance values extremely different each other?
YES: Repair or replace the combination meter (printed circuit board). The door ajar warning light should work normally.
NO (much the same): Go to Step 7.
STEP 7. Check the combination meter power supply circuit at the combination meter connector C-102.
1. Disconnect the combination meter connector C-102 and measure at the harness side.
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage between terminal 31 and ground.
Q: Is the voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 10.
NO: Go to Step 8.
