Stratus Coupe V6-3.0L VIN H (2001)
STEP 7. Check the harness wires between ETACS-ECU connector C-311 and battery.
NOTE: After checking junction block connector C-308 and intermediate connector C-209, check the wires. If junction block connector C-308 and
intermediate connector C-209 are damaged, repair or replace them. Refer to Harness Connector Inspection.
Q: Are the harness wires between ETACS-ECU connector C-311 and battery in good condition?
YES: There is no action to be taken.
NO: Repair them. The turn-signal lights should flash normally.
STEP 8. Check the input signal (by using scan tool MB991502).
Check the input signals from the following switches.
-
Ignition switch (IG1)
-
Turn-signal light switch
CAUTION: To prevent damage to scan tool MB991502, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991502.
1. Connect scan tool MB991502 to the data link connector.
2. Check that the tone alarm of scan tool MB991502 sounds when the input signal enters.
Q: Does the tone alarm of scan tool MB991502 sound when the input signal enters?
YES: Replace the ETACS-ECU. The turn-signal lights should flash normally.
NO: Check the relevant input signal circuit.
STEP 9. Check the input signal (by using a voltmeter).
Check the input signals from the following switches.
-
Ignition switch (IG1)
-
Turn-signal light switch