Stratus Coupe V6-3.0L VIN H (2001)
signal is an error, these functions will not work normally.
TROUBLESHOOTING HINTS
-
Malfunction of the driver's inner seat belt (driver's seat belt switch)
-
Malfunction of the ETACS-ECU
-
Damaged harness wires or connectors
DIAGNOSIS
Required Special Tools:
-
MB991223: Test Harness Set
-
MB991502: Scan Tool (MUT-II)
-
MB991529: Diagnostic Trouble Code Check Harness
STEP 1. Check the driver's seat belt switch.
Q: Is the driver's seat belt switch in good condition?
YES: Go to Step 2.
NO: Replace the driver's inner seat belt. The driver's seat belt switch input signal should be able to be checked and the functions, which are described
in the "Technical Description (comment)," should work normally.
STEP 2. Check the driver's seat belt switch ground circuit at driver's seat belt switch connector D-15.
1. Disconnect driver's seat belt switch connector D-15 and measure at the harness side.
2. Measure the resistance between terminal 1 and ground.
Q: Is the resistance less than 2 ohm?
YES: Go to Step 5.
NO: Go to Step 3.
