dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Component Tests and General Diagnostics|Page 2090 > < Component Tests and General Diagnostics|Page 2088
Page 243
background image

STEP 6. Check the harness wires between trunk lid lock key cylinder switch connector F-06 and ETACS-ECU connector C-312.

NOTE:  After checking intermediate connector C-210, check the wires. If intermediate connector C-210 is damaged, repair or replace it. Refer to
Harness Connector Inspection.

Q: Are the harness wires between trunk lid lock key cylinder switch connector F-06 and ETACS-ECU connector C-312 in good condition?

YES: Replace the ETACS-ECU. The input signal from the trunk lid lock key cylinder switch should be able to be checked and the theft-alarm system
should be armed normally.
NO: Repair them. The input signal from the trunk lid lock key cylinder switch should be able to be checked and the theft-alarm system should be
armed normally.

Inspection Procedure O-14

The speed sensor.Signal Is not sent to the ETACS-ECU.

Component Tests and General Diagnostics|Page 2090 > < Component Tests and General Diagnostics|Page 2088