Viper SRT-10 V10-8.4L (2008)
PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - MIL On/DTC P0300/Limp Home Mode
NUMBER: 18-015-08
GROUP: Vehicle Performance
DATE: April 5, 2008
THE StarSCAN(R) FLASH FILES FOR THIS BULLETIN MUST BE RETRIEVED FROM THE INTERNET.
StarSCAN(R) SOFTWARE LEVEL MUST BE AT RELEASE 8.04 OR HIGHER.
StarMOBILE DESKTOP CLIENT -OR- StarMOBILE STANDALONE MODE MAY ALSO BE USED TO PERFORM THE FLASH.
SUBJECT:
Flash: MIL Illumination with DTC P0300 - Multiple Cylinder Misfire Set
OVERVIEW:
This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) and performing the Learn ETC routine with the
StarSCAN(R).
CAUTION:
Be sure to follow the Repair Procedure steps in the order listed.
MODELS:
2008
(ZB)
Viper
NOTE:
This bulletin applies to models equipped with a 8.4L engine (Sales Code EWE) built prior to April 1, 2008 (MDH 0401XX).
SYMPTOM/CONDITION:
Some customers may experience MIL illumination along with a limp in condition with limited power after the MIL. Further investigation by the
technician may find Diagnostic Trouble Code (DTC) P0300 - Multiple Cylinder Misfire is set.
DIAGNOSIS:
Using a scan tool with the appropriate diagnostic procedures available in TechCONNECT verify all engine systems are functioning as designed. If
DTC's other than those listed above are present record them on the repair order and repair as necessary before proceeding further with this bulletin.
If the above symptom/condition is experienced and cause for DTC's cannot be determined, perform the following repair procedure.
PARTS REQUIRED:
SPECIAL TOOLS / EQUIPMENT REQUIRED: