Viper SRT-10 V10-8.4L (2008)
REPAIR PROCEDURE - USING THE INTERNET TO RETRIEVE THE FLASH FILE:
NOTE:
If this flash process is interrupted/aborted, the flash should be restarted.
NOTE:
It is recommended that the flash procedure be performed with the StarMOBILE DESKTOP CLIENT -OR- StarMOBILE STANDALONE MODE.
1.
Turn ignition key off.
2.
Disconnect gateway module under drivers seat. To access the module the driver seat must be fully reclined.
3.
Disconnect the occupant classification module (0CM). Follow the detailed service procedures available in DealerCONNECT/TechCONNECT,
Refer To Group 8 - Electrical > Restraints - Service Information > Module - Occupant Classification (0CM) > Removal.
4.
Turn ignition key on.
5.
Reprogram the PCM with the latest software. Follow the detailed service procedures available in DealerCONNECT/TechCONNECT, Refer To
Group 8 - Electrical > Electronic Control Modules - Service Information > Module - Powertrain Control > Standard Procedures> PCM/ECM
Programming - Gas.
6.
Type the necessary information on the "Authorized Modification Label" and attach it near the VECI label.
CAUTION:
Perform the step below in the order listed.
7.
Turn ignition key off.
8.
Connect gateway module under drivers seat. To access the module the driver seat must be fully reclined.
9.
Connect the occupant classification module (0CM). Follow the detailed service procedures available in DealerCONNECT/TechCONNECT, Refer
To Group 8 - Electrical > Restraints - Service Information > Module - Occupant Classification (0CM) > Installation.
10.
Using the StarSCAN(R) perform the learn ETC procedure.
11.
Turn the Ignition key to the off position for 15 seconds.
12.
Turn the Ignition key on.
13.
Erase DTC's.
14.
Turn the Ignition key to the off position for 15 seconds.
15.
Start vehicle.
16.
If vehicle runs extremely rough or has zero pedal response perform learn ETC procedure again.
NOTE:
Due to the PCM programming procedure, a DTC will be set in other modules within the vehicle, if so equipped. Some DTC's may cause the MIL to
illuminate. From the "Home" screen select "System View". Then select "All DTCs". Press "Clear All Stored DTCs" if there are any DTCs shown on
the list.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE: