Viper SRT-10 V10-8.4L (2008)
Electronic Brake Control Module: Service and Repair
Removal
REMOVAL
1. Disconnect battery negative (-) terminal.
2. Raise and support vehicle. See: Maintenance
3. Remove left front tire and wheel assembly. See: Maintenance/Wheels and Tires/Service and Repair/Removal and Replacement/Tires and Wheels -
Removal
4. Remove access panel in forward portion of left front wheel well.
5. Pull outward on connector lock and disconnect 24-way connector (2) at CAB.
6. Disconnect pump/motor wiring harness connector at CAB.
7. Remove four CAB mounting bolts (3).
8. Slide CAB off HCU and remove.