Vision V6-201 3.3L (1993)
Wheel Speed Sensor: Service and Repair
Front
Inspect tone-wheel for missing or broken teeth, ensure tone-wheel has not made contact with wheel speed sensor. Replace tone-wheel if runout
exceeds 0.010 inch.
1. Raise and support vehicle, then remove tire and wheel assembly.
2. Remove grommet retaining clip attaching screw, then pull sensor assembly grommet from fender shield.
3. Unplug speed sensor connector from vehicle wiring harness connector, then remove speed sensor cable routing bracket from front strut
assembly.
4. Remove screw attaching speed sensor head to steering knuckle, then sensor from steering knuckle. Do not use pliers on sensor head, use a
hammer and punch to tap edge of sensor ear, rocking sensor side to side until free.
5. Reverse procedure to install noting the following:
a. Coat sensor head with high temperature multi-purpose E.P grease.
b. Torque speed sensor head to 60 in/lbs.
c. In two steps, torque wheel lug nuts to 95 ft/lbs.
