Workshop Manuals Factory service & repair Fiat
01 00 Introduction and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 33 Braking system06 41 Steering07 44 Suspension and wheels08 50 Auxiliary units09 55 Electrical system10 70 Bodywork
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)01 · 00 Introduction and technical data
01 · General

Identification data (page 3 of 3)

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Identification data
00 Introduction and technical dataIdentification data · page 3 of 3
Table of vehicle weights and loads for various engine types
WEIGHTS (in kg) ENGINE TYPE 1370
12V
1581
16V
1747
16V
1998
20V
1929
D
1910
TD
3 door 1010 1050 1100 1190 1100 N.D.
1040 1090 1130 - 1130 N.D.
+500 = 150
3 door
1510 1550 1600 1690 1600 N.D.
1570 1630 1680 - 1650 N.D.
Maximum permissible loads
on the axles ■
3 door 850 850 900 970 850 N.D.
5 door 850 850 900 - 850 N.D.
3 door 850 850 900 900 850 N.D.
5 door 850 850 900 - 850 N.D.
Maximum permissible load on the roof 80 80 80 80 80 N.D.
Load on the tow hook
(trailer with braking system)
Minimum - - - - - N.D.
Maximum 70 70 70 70 70 N.D.
Without braking
system
400 400 400 400 400 N.D.
With braking
system
1000 1100 1200 1300 1200 N.D.

■ Loads which must never be exceeded

NOTE FOR VERSIONS WITH ACCESSORIES: If special equipment is fitted (non standard air conditioner, sun roof, trailer towing device), the empty weight increases and therefore the carrying capacity may decrease, in relation to the maximum permissible loads.

The fuel consumption figures according to the 80/1268/EEC standards given overleaf have been defined in the course of official tests and in accordance with procedures laid down by EEC regulations. In particular the bench tests measure simulated urban cycle figures whilst consumption at constant speeds of 90 and 120 kph are measured directly on a flat, dry road and in equivalent bench tests. The fuel consumption figures according to the 93/116E standards have been defined in the course of homologation tests involving:

  • an urban cycle which includes cold starting followed by a varied urban cycle simulation.
  • an extra-urban cycle which includes frequent acceleration in all gears simulating normal extra-urban usage of the vehicle. The speed varies between 0 and 120 kph.
  • The average combined consumption is obtained from 37% of the urban cycle and 63% of the extra-urban cycle.

The type of journey, traffic conditions, driving styles, atmospheric conditions, trim level/equipment/accessories, whether a roof rack is fitted, the presence of special equipment and the general state of the vehicle can lead to fuel consumption figures which differ from those obtained through the above mentioned procedures.

The CO₂ exhaust emissions (in g/km) are obtaine from the average combined cycle

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.