Workshop Manuals Factory service & repair Fiat
Fiat Bravo/Brava (182) Factory Service Manual (1995-2001)04 · 21 Gearbox and differential
04 · Transmission

Dismantling

Make
Fiat
Model
Bravo /Brava (182) Factory Service Manual
Year
1995–2001
Section
Drive shafts (1747 16v) › Dismantling
21 Gearbox and differentialDismantling
Diagram of a constant velocity joint on a drive shaft
Diagram showing tools 1860889000 and 1847017001 being used on a drive shaft

DISMANTLING

  1. Remove the clip and the protective gaiter on the constant velocity joint, wheel side.

During assembly, it is advisable to replace the protective gaiter.

  1. Clean the grease off the inside of the constant velocity joint and, using tools 1847017001 and 1860889000, remove the constant velocity joint and then withdraw the protective gaiter, previously moved aside, from the drive shaft.
  2. Remove the protective cover from the constant velocity joint, gearbox side.
  3. Remove the two clips securing the protective gaiter on the gearbox side, then remove it.
  4. Clean the grease off the inside of the constant velocity joint and remove the circlip from its seating.
Diagram showing the constant velocity joint being withdrawn from the drive shaft
Diagram showing the protective cover and clips on the gearbox side of the constant velocity joint
Diagram showing a circlip being removed from the constant velocity joint seating with pliers
Removing center cap from wheel hub assembly

Parts & tools for this job For 1995 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.