Brake fluid reservoir

BRAKE FLUID RESERVOIR

Checking low brake fluid level indicator

NOTE Periodically check the operation of the indicator by pressing on the top of the reservoir cover (as shown by the arrows); with the ignition ON, the braking system fault warning light should come on.

Removing-refitting

To remove the brake fluid reservoir, proceed as follows:

• disconnect the sensor connector and undo the cap;
• remove the brake fluid from the reservoir, using the special syringe;
• pull the reservoir upwards to remove it.

Take care should any residual fluid emerge from the reservoir.

NOTE To refit the brake fluid reservoir, reverse the procedure for removal.

Before filling the reservoir, make sure that it is thoroughly clean.

Bleed the hydraulic system