STEERING WHEEL Removing-refitting

P4A39DA01

P4A39DA03

P4A39DA04

P4A39DA02

STEERING WHEEL Removing-refitting

Remove the air bag module from the steering wheel as described in Section 55.

1. Unscrew the nut retaining the steering wheel to the steering column, the disconnect the horn electrical connection and remove the steering wheel.
2. Mark the positions of the steering wheel hub and steering columns and remove the steering wheel.

During the operation, take care NOT TO STRIKE THE STEERING WHEEL.

The clock spring is fitted with a safety clip to prevent the lower and upper plates turning in relation to one another when the steering wheel is not fitted in the car. This is achieved by springs (1), which close as shown in the figure.

Remove the clock spring as described in Section 55.

STALK UNIT-RELEASE Removing-refitting

Remove the stalk unit-release as follows:

3. Use a socket wrench to loosen the bolt of the stalk unit-release retaining collar and withdraw.
4. Disconnect electrical connectors from the stalk unit-release and remove.