Dismantling-refitting

Variable ratio rack-and-pinion steering gear

Dismantling-refitting

1. undo the nuts shown and remove the steering damper;

2. slacken the tie-rod locking nut then unscrew the tie-rod until you can remove it;

NOTE Check that there is no stiffness or excessive play on the balljoint, otherwise it will need to be replaced.

3. undo the clamps on the dust gaiter and lubricating seal, and remove the gaiter.

NOTE Thoroughly check the gaiter for holes or tears, and if necessary replace it.

Before fitting the last gaiter (pinion side), insert the specified quantity of grease.