Radiator-distributor unit

RADIATOR-DISTRIBUTOR UNIT

Removing

• Drain the engine's cooling system;
• remove the top trim on the tunnel and dashboard (see pages 30 and following in Section 70);
• working at the bottom rear of the car's engine compartment, undo the two clips shown by the arrows in the figure opposite and disconnect the two rubber pipes from the ends of the metal pipes protruding in the engine compartment, which are connected to the split connector on the heater radiator;
• undo the bolts shown by the arrows in the figure underneath which attach the radiator-idistributor unit to the body shell;
• disconnect the wiring connector (1) and remove the unit from the car;