2. Cleaning

Figure : B3FG246D

Disconnect the hose union (2) from the brake caliper (3).

Close : The brake caliper (3).

Remove :

• The rear brake pads (see the relevant operation)
• The bolts (4)
• The rear brake caliper (3)

2. Cleaning

ESSENTIAL : Do not use compressed air to clean the brakes.

2.1. 1st possibility

Clean the brake disc and the brake caliper (3); With a recommended brake cleaning product.

Allow to dry and to drain.

Wipe; Using a paper cloth.

2.2. 2nd possibility

Use an approved dedusting instrument (see tools and equipment catalogue).

Visually check :

• Around the pistons for leak
• That the protective gaiters are in good condition and correctly adjusted
• The disc for wear

Check the operation of the brake caliper (3).

3. Refitting

CAUTION : Adhere to the tightening torques.

Refit :

• The rear brake caliper (3)
• The bolts (4) (new) (pre-coated with a thread locking product)

Tighten the bolts (4).

Fit the brake pads (see the relevant operation).

Couple the flexible hose (2) on the brake caliper (3).

Position the hose union (2) on its support.

Couple the flexible union (2) to the rigid brake piping.

Refit the clip (1).

Bleed the brake system (see the relevant operation).

Apply the brakes, with the engine running, several times before driving the vehicle.

Check the operation of the brakes.

Fit the wheels.

Return the vehicle to its wheels.

Tighten the wheel bolts.