1. Removing

1. Removing

Remove the rear suspension (see the relevant operation).

Figure : B3BP1CLD

Uncouple the handbrake cable from the cable guide ( 6 ).

Remove :

• The (4) bolt
• The rods (5)
• The cable guide (6)
• The nuts (2)
• The clamps (1)
• The suspension blade (3)

2. Refitting

CAUTION : Always fit new Nylstop nuts.

Figure : B3BP1CMD

Locate suspension blade ( 3 ).

N.B. : Ensure that the centring pin ( 7 ) is positioned in the location " a ".

Refit :

• The clamps (1)
• The nuts (2); Tighten to 13 ± 3,9 daN.m
• The rods (5)
• The (4) bolt
• The cable guide (6)

Couple the handbrake cable to the cable guide ( 6 ).