4. Refitting

• Remove the adhesive sealing bead
• Remove any dust using a clean cloth

On the new component :

• Degrease the aperture
• Apply the metal primer provided in the bonding kit part number "A3"
• Allow to dry for 10 mn

4. Refitting

Figure : C5CM01WD

"A" = 12 mm .
"B" = 8 mm .
Cut the nozzle in triangular section to obtain a bead of sealing adhesive "B" wide and "A" deep.

ESSENTIAL : Always replace the seals.

4.1. Re-use of the quarter window

Apply the adhesive sealing bead on the surround of the quarter window (3) (at "c").

ESSENTIAL : Use of the two part product: the time for fitting the window on the vehicle and the start of extrusion of the sealing adhesive is 5 minutes.

Refit the rear quarter window :

• Using the double hinged suction cups [KIT1-VENT]
• Using adhesive tapes (1)

Check the clearances and flushness of the rear quarter light.