7.7. Trapped wire

• Method for stripping a wire (5.3)
• Method for selecting a wire (5.2) (In the case of an unusable wire)
• Method for restoring the covering (5.12)
• Method for selecting a protector (5.13)

ESSENTIAL : If the wire is unusable and a passage hole is available, fit a grommet; If an additional wire is available, use it and carry out the operations on each side of the overmoulded connector.

ESSENTIAL : If more than 4 wires are cut, the harness must be replaced.

7.7. Trapped wire

Figure : D6AM040D

Trapped wire.
Apply the following methods in order :

• Method for checking a wire (5.1)
• Method for stripping a wire (5.3)
• Method for selecting a wire (5.2) (In the case of an unusable wire)
• Method for restoring the covering (5.12)
• Method for selecting a protector (5.13)

ESSENTIAL : If the wire is unusable, cut the wire at the accessible points (near the connectors) and apply section 4.1 observing 2 rules : Remain in the same harness, retain the numbering of the wires (Cut the wire in such a way as to retain the numbered ends).

ESSENTIAL : If more than 4 wires are trapped, the harness must be replaced.