2. Removing (page 2 of 3)

Place the vehicle on a 2-post lift.
Disconnect the battery negative terminal.

• The protection plates under the engine
• The front right wheel

CAUTION : Prior to removal, and before any subsequent refitting of the ancillary drive belt that has been removed, it is compulsory for the engine to be at ambient temperature (Below 30 °C). In all other cases, replace the ancillary drive belt.

N.B. : Removing it with the engine hot causes irreversible and invisible damage to the ancillary drive belt.

CAUTION : If replacing it, cut and remove the ancillary drive belt.

CAUTION : Check that the tool [0198-P] is correctly positioned between two teeth of the flywheel; or turn the crankshaft to correctly position the tool.

Move aside and secure : The starter motor.

Figure : B1BG2YHD

Position the tools [0198-P], [0198-E].
Secure the assembly using the starter motor bolts.