2. Refitting (page 2 of 2)

Figure : C5FP0YXD

Position the rotary switch on the controls under the steering wheel.

N.B. : Align the failsafe " d " with the groove " e " on the steering wheel angle sensor (10).

Refit and tighten the 3 screws (8).

Connect the connector "b".

Cut and remove the plastic collar.

Refit :

• The steering column upper cowling ( 6)
• The (7) bolt; Tighten to 0,2 ± 0,02 daN.m
• The bolts (5); Tighten to 0,2 ± 0,02 daN.m
• The lower trim on the steering column (3)
• The bolts (2); Tighten to 0,2 ± 0,02 daN.m
• The bolts (4); Tighten to 0,2 ± 0,02 daN.m
• The lower panel (1) (see the relevant operation)
• The steering wheel (see the relevant operation)

Reconnect the battery.

Check that the steering wheel electrical controls operate correctly.