Rear connection central pipe - r r

Operation 3340B62 · ABS SYSTEM PIPES

Removing

Place the car on a ramp.

- 3330C34 brake fluid reservoir - r + r and wash inside - versions with r/h drive and abs

- 5530B10 battery - r+r

- 5530B56 BATTERY DRIP TRAY COVER - R.R.

- 5530B52 Battery DRIP TRAY/SUPPORT - R.R.

- 1048A10 air cleaner filtering element - replace

- 3330C14 (PUMP) - MASTER CYLINDER .R.R for versions with A.B.S.

- 3340A12 A'B.S. system. - electronic and hydraulic CONTROL UNIT R.R.

Raise the lift.

1. Open the brake pipe retaining clip

1. Undo bolts (1a) and remove retaining clip (1b).

2. Remove the front section of the rigid brake pipe and fuel pipe protection

1. Undo the connector on the rigid pipe from the master cylinder, lower the lift and remove it from the upper part of the engine compartment.

Refitting

Fit the rigid pipe from ABS hydraulic control unit to connection.

Tighten the rear brake pipe intermediate rigid section connection to torque.

Fit the front section of the rigid brake pipe and fuel pipe protection and tighten the bolts and front side clip.

Secure the two rigid pipes from the ABS control unit to the connectors, in the lower body fastening clip.

- 3340A12 A'B.S. system. - electronic and hydraulic CONTROL UNIT R.R.

- 3330C14 (PUMP) - MASTER CYLINDER .R.R for versions with A.B.S.

- 1048A10 air cleaner filtering element - replace

- 5530B52 Battery DRIP TRAY/SUPPORT - R.R.

- 5530B56 BATTERY DRIP TRAY COVER - R.R.

- 5530B10 battery - r+r

- 3330C34 brake fluid reservoir - r + r and wash inside - versions with r/h drive and abs

- 0010T64 brake and or clutch fluid check level and top up as necessary

- 0010T65 hydraulic brake system bleed air