Workshop Manuals Factory service & repair Fiat
Fiat Punto (176) Factory Service Manual (1993-1999)01 · 00 Introduction and technical data
01 · General

Wheel geometry

Make
Fiat
Model
Punto (176) Factory Service Manual
Year
1993–1999
Section
Wheels (Cabrio, 1242 SPI, 1581) › Wheel geometry
00 Introduction and technical dataWheel geometry · page 1 of 2
Technical data table for wheel geometry showing specifications for 1242 SPI and 1581 engines on an unladen car, including camber, caster, toe in, offset, and thrust angle values with accompanying suspension diagrams.

WHEEL GEOMETRY

Front
suspension		 1242 SPI 1581
camber (**) - 25' ± 30' - 15' ± 30'
caster (**) 1° 20' ± 30' 2° 50' ± 30'
toe in 0 ± 1 mm
front wheel offset ▲ 0°
Rear
rear		 camber (**) - 25' ± 30' - 20' ± 30'
toe in (**) 1 ± 2 mm
rear wheel thrust angle ▲ 0°

(*) With tyres inflated to the correct pressure and vehicle in running order

(**) Angles cannot be adjusted

(▲) Angular values, which cannot be adjusted, used for the correct alignment of the vehicle

Original page

Parts & tools for this job For 1993 Fiat Punto

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.