Removing-refitting alternator (page 2 of 2)

1. Remove the alternator rear bolt. Remove the alternator drive belt from the air conditioner compressor pulley, then remove the alternator front bolt (slackened previously). 2. Gently withdraw the alternator from the engine compartment and rotate it as in the figure; raise the protective cover and disconnect the supply cables. Then remove the alternator complete with its drive belt. 3. On the bench, remove the alternator pulley guard and remove the drive belt. 4. A115I 14V 85A alternator (versions with air conditioning); on the versions with heating, the alternator is A115I 14V 65A. When refitting, retension the alternator drive belt to a tension of 30 - 41 daN to be measured using tool 1895762000. If a new belt is fitted, tension it to 48 - 60 daN.