Bodywork

Bodywork

Structural sheet-metal parts replacement

1. Using a jig saw make two further cuts as shown in the diagram to obtain two flaps allowing access to the pillar welds.
2. Reduce the welds using a drill.
3. Remove the pillar.

Removing the blanks and preparing the edges of the body

1. Reduce the welds using a drill.
2. Reduce the welds using a spot cutter.
3. Trim the sheet metal and straighten the edges of the body.
4. Remove the residues left from welding using a disk grinder.
5. Apply electro-galvanizing paint to the area shown in the diagram.