Workshop Manuals Factory service & repair Fiat
Fiat Punto (176) Factory Service Manual (1993-1999)10 · 70 Bodywork
10 · Body & interior

Preliminary operations (page 4 of 4)

Make
Fiat
Model
Punto (176) Factory Service Manual
Year
1993–1999
Section
Window glasses (Cabrio)
70 BodyworkPreliminary operations · page 4 of 4
Interior view of the vehicle showing the anchorage of the tensioning belt under the floor panel
- position the special tool from inside and outside the vehicle; - suitably connect the special tool using the appropriate belts;

NOTE The inset illustrates the anchorage of the tensionining belt under the floor panel.

Rear exterior view of the vehicle showing the special tool adhering to the perimeter of the rearscreen edge with adjustment nuts indicated by arrows
- check that the special tool adheres to the perimeter of the rearscreen edge, if this is not the case, regulate the adjustment nuts shown by the arrows;
Interior view showing the connection of positive and negative cables for the rearscreen resistance to a 12 V battery
Using insulating tape, protect the electrical resistance cables. - connect the positive and negative cables for the rearscreen resistance to the poles of a 12 V battery; - wait for about 100 seconds; - wait about 15-20 minutes before removing the special tool.

Parts & tools for this job For 1993 Fiat Punto

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.