Aerostar V6-183 3.0L (1986)
FIGURE 9
FIGURE 10
FIGURE 11
The caliper pin removal tool is recommended for use on all the above listed vehicles, including 1988 Super Duty, Figures 8 through 11. This caliper pin
tool can be made from a 1/2 inch diameter rod 7 inches long. Simply grind or cut a "V" notch in one (1) end. The "V" notch is used to compress the pin
retention tabs while the tool is also used to drive the pin out of the caliper slide groove. This tool replaces a pair of pliers and screwdriver as outlined in
the Shop Manual service procedure.