Bronco L6-300 4.9L VIN Y 1-bbl (1983)
3.
Acid Rain
^
Surface will exhibit irregular discolored spotting.
^
Dark colored vehicles will show cloudy or greying spots where the acids have started to etch away the paint.
NOTE:
IN EXTREME CASES ETCHING OF THE SURFACE WILL BE VISIBLE OR FELT.
DECONTAMINATION
Use Finish Kare Inc. products 1119/883/11850 to decontaminate the paint surface. Follow the manufacturer's recommended procedures.
NOTE:
FORD DOES NOT RECOMMEND THE USE OF OXALIC ACIDS OR OTHER "FALLOUT REMOVERS".
1.
Rinse off dust and debris with cold water. Be sure to start at the bottom and work up.
2.
Prepare product "1119" by mixing one (1) part "1119" with four (4) parts cold water.
3.
Use clean wash mitt and apply mixture to entire car, starting at the bottom and working up to the top surface. Keep car wet with the solution for 5
to 10 minutes. Do not allow product to dry on the car, and do not allow it to streak down the sides. Rewipe with mitt if necessary to avoid streaks.
4.
Rinse car with cold water.
5.
Dry the flat surfaces of the vehicle hood, roof and deck lid.
6.
Apply product "883" directly to the contaminated surfaces using a clean dry sponge, wash mitt, or soft truck brush ("883" is ready to use from the
bottle, with no mixing involved). Keep the areas wet with the "883" for 5 to 7 minutes. Do not allow to dry on the car. Wipe down to the body line
on the sides.
7.
Prepare product "118SC" by mixing 1 oz (0.03 L) with 1 gal (3.785 L) of water.
8.
Shampoo the vehicle with "118SC" shampoo mixture using a clean wash mitt and then rinse with cold water.
NOTE:
DO NOT USE "1185C" MITT WITH "1119" OR "883" SOLUTIONS. USE SEPARATE MITTS AND ALWAYS KEEP THEM SEPARATE.
9.
Inspect paint surface to see if rust particles have been removed. If rust particles have been on the vehicle for a long time, it may be necessary to
repeat each of the above steps.
NOTE:
THE NEUTRALIZER CONCENTRATE IS A HEAVY DUTY SHAMPOO AND CAN BE USED IN AN AUTOMATIC CAR WASH SYSTEM.
